This demonstration is at Industrial Degauss’s trade show booth; it shows a magnetized pipe holding a hammer and a piece of steel until the IDMAG System is used to demagnetize it. You can see how easily our equipment demagnetizes the pipe!
The pipe used in the fab shop was magnetized and the IDMAG Pipeline Demagnetizer was used to demagnetize the pipe ends. A magnetic survey was performed at the beginning with a high measurement of 90 gauss. Within 20 minutes, the equipment was set up and the pipe end was degaussed. The resulting value was reduced to less than 1 gauss and welding was able to proceed.
Industrial Degauss is the leading provider of pipeline demagnetizing equipment and services.
Magnetized pipe causes arc blow, porosity and other issues during welding. If you ask around you will hear many different methods – reverse the polarity of the leads, wrap an odd number of welding leads around the pipe, use an AC welder, strike it with a sledgehammer, lay the pipe East-West… none of them will help you avoid delays.
The IDMAG system is the right tool for the job. It can be overnighted to your location and in short time you will be able to weld without any issues.
Call us today at 747-334-2877 or contact us at email@example.com to discuss your application.
A valve was being installed on a 42″ pipeline. The line had been pigged in the past and the contractor knew that the pipe was going to be heavily magnetized and would need to be demagnetized prior to welding. Using a welder and wrapping the welding leads would not be enough to demag this pipe.
The IDMAG System was used to successfully demag the pipe and allow the welders to do their job.
The IDMAG System is available to rent and on-site demag services are also available.